While taking the family photo of the controller & headphone holders on Monday, I was looking at the headphones sitting in the Tri-Arc holder mentioned earlier this month. I realized, much in the same way Read more…
Hello hello! These last two weeks or so, we’ve been working on the “weird wall holder” which I have decided to name “The Eye in the Sky” (because The Alan Parson’s Project rules). It started Read more…
This has been a bit of a troublesome print! The first successful print wasn’t quite functional, and then the next 2 prints failed for various reasons, but today we finally have a successful one that Read more…
Still working on holders and things like that for the time being. Following on the “New Methods” post from last week, this is the weird wall mounted holder that I made using control point curves Read more…
Hello hello! Apologies for the lack of content yesterday – I got stuck working on work for a lot longer than I had anticipated and by the time all that was finished it was well Read more…
The Nintendo Switch is a ton of fun. The hot-swap capability of being a living-room, handheld, and “laptop” console is super rad (and The Legend of Zelda: Breath of the Wild is super fun). This Read more…
Whoooooops, did not hit the publish button on this guy yesterday. My bad! I was thinking yesterday while watching my 3D printer extrude another part of the headphone holder base, that the hotend kind of Read more…
Doesn’t mean you should. And also some other lessons from the office today. That’s the fun part of experimentation, and the whole point of this project: to figure out where the boundaries are. Below is Read more…
We got our 3D printer the other day, so we decided to get printing right away! Use Case: Notebooks are good to bring around with you to jot down ideas or just when you go Read more…